Today I managed some time to put a smallish red gum burl onto the Wood Wizz Milling machine to flatten the two surfaces.
The burl had previously been filled with a two part clear casting epoxy resin - more about that in another post. The epoxy had left some local raised blobs of hardened resin that I needed to shave off before finishing.
Over a period of time the burl had developed a small convex dome shape which became apparent during the milling process.
Milling off the central domed area of epoxy covered top surface.
Domed area milled further.
Further pass has removed most of the central domed area except towards the lower left edges.
Finally a flat top surface to our burl. Some sanding needed to reduce signs of the cutting teeth of the Wood Wizz.